Laser cutting for manufacturers
Repeat production parts, cut and folded to your drawings, with every order checked from start to end by Auto360, our order system.

What Auto360 does
Suited to manufacturers who order the same parts, kits or BOMs again and again.
Your parts on file
One part number for each of your parts, with its drawing. When a drawing changes, the new revision waits for your approval, then replaces the old one. Earlier revisions are archived, never cut by mistake.
Purchase orders read in
Send your purchase order as you do today. It is read in automatically, and each line is matched to your part number and its approved revision.
The 360 check
Part, revision, quantity and date are checked when the order arrives, and again before it reaches the floor. Anything that does not match is raised with you before cutting starts.
Kits and BOMs
Order a kit or a bill of materials as one line, and every part in it is cut, folded and sent together.
From your order to delivery
Read
Your purchase order comes in and is read.
Match
Each line against your part number, revision and quote.
Check
Any difference is raised with you, with the reason.
Release
A clean order goes into production: cut, folded, checked and delivered.
Set up for repeat production work
Consistent at every step
Systemised processes from quoting and material selection through programming, cutting, folding, packaging and delivery.
Under one roof
Sheet laser, tube laser and press brake in one building, so a part moves from the laser to the press brake without leaving it.
Send your files. A quote usually comes back the same day.
DXF, DWG, STEP or PDF. If you are not sure which service a part needs, send the drawing and we will advise.
